DIY : How to install a front lip spoiler - MBWorld.org Forums

Hey Guys,

My spoiler came in 2 days ago and I decided to wait for some good weather to take pictures while me and my dad install so you can see how it is done.

This is where you can get the spoiler: http://cgi.ebay.com/ebaymotors/Merce...205|240%3A1318]

The spoiler already comes with tiny pre drilled holes and a set of screws you will need to install. The worst part about installing this spoiler is lining it up so it sits perfect. You can do it yourself but if you have a person that could help it would be much easier to line it up.

Tools needed :

1. CAR JACK with a stand or 2 just to be safe
2. Philips screw driver

That is all!

I will show pictures with each step. This is the easiest way to install this and put it on. You will see a drill on the picture we only used the drill to screw in the screws to the spoiler in the beginning.

STEP 1 : Lift the car so that the entire front end is up at both sided. This will give you room to work and line up the front lip.

STEP 2 : Pre drill the original spoiler with the screws provided, this way it will be much easier to screw it on while it is up in the air.

This is how far the screws should be sitting before you start the line up

STEP 3 : Line up the spoiler. MAKE SURE YOU DONT LINE IT UP LOOKING AT THE FRONT, LOOK AT THE ENDS OF THE LIP AND MAKE SURE IT SITS EVEN ON BOTH SIDES.

STEP 4 : If you can have someone hold the lip in place while you drill the screws in with the philips screw driver. Start from each end L and R. Do the middle once both of the sides or bolted on and sit perfectly. There is a little hold at each end so you can get the philips in and bolt it on.

STEP 5: Make sure every screw is on tight. AND YOU ARE DONE.

FINISHED PRODUCT: